Hallo Alles,
Ich denke, ich habe eine problem mit der spannung von die ECU zum lambda sensor.
Ich habe der 1.4 BBY engine. Ich bekomme 10.4 volts an die ECU seite auf pin 5. Meiner meinung nach, diese spannung sollten nur 5 volts sein.
Wenn jemand hat einen A2 mit den BBY motor, versuchen sie bitte pin 5 an ihrem motor und sehen sie welche spannung sie bekommen.
Vielen dank für Ihren helfen, und ich habe die englischen ubersetzung unter legen.
Beste Grüße
Neil
Hi All,
trying to bottom out a potential bias voltage problem to the Pre Cat lambda sensor.
I have 1.4 BBY engine and getting 10.4 volts through pin 5 (Vs+) on the connector from the ECU when probed with the ignition on and 12.4 when the car is running. I am earthing the multimeter with pin 6 on the connector.
If anybody with a BBY engine (or I suspect results will be same for an AUA engine) and a multimeter can check the voltages seen on their connector it would greatly appreciated. It could be right, but I would have expected a reference voltage of 5V from the ECU.
any help would be greatly appreciated.
Thanks and regards
Neil