Gearbox reset problem (can't reach 1,8-2,0v)

[luzt]

Hey!

Let me start of by apologizing for writing in english, but this is a last resort!

 

When adjusting the wire to the clutch, when doing a gearbox default setting, I can't get the value to reach the recomended ones.

 

The only values that the gearbox responds to is ~0,5-0,6v. Within this spectrum I'm able to complete a full reset. (No response when pushing the brake pedal in any higher values)

 

I'm getting a feeling that the sensor for the wire is broken, there by leaving me with no option but to replace the whole thing.

 

 

 

http://www.ebay.de/itm/Kupplungs-Nehmerzylinder-Gangsteller-VW-Lupo-Audi-A2-3l-/140593957152?pt=DE_Autoteile&fits=Make%3AAudi|Model%3AA2&hash=item20bc0d8920

 

Is this a correct assumption?

And is there anyone who has made such a repair them selves and have any pictures/guides? Because I get the feeling that I have to remove a lot of parts to be able to get it out and the new one in.

[Nachtaktiver]

Yes, this should fit into your TDI.

[DerWeißeA2]

You can buy it much cheaper at Audi. I payed 187,- € excl. tax in Germany.

 

An instruction how to change it I have written here. Sorry for explaining it in german.

 

But before you change the clutch slave cylinder (?), have a look at the brake pedal switch.

 

BTW: Are there any fault codes?

 

 

Mark